Description:
ADFLEX-RW is a single part cold applied, high build water based bitumen compound. Formulated specially as a safe, easy to use economical waterproofing barrier and anticorrosion coating.
Purpose:
For the protection of concrete, masonry, steel and wooden structures. Particularly suitable for buried, immersed or wet conditions. ADFLEX-RW may be painted with water based acrylic paints.
Typical uses:
-
Waterproofing:- Retaining Walls, Planter Boxes, Pond Lining, Tanking.
-
Corrosion Control:- Galvanised Steel Culverts, Steel Tunnel and Tank Lining, Cast Iron Pipes, Steel Piping.
-
Sound Deadening:- Soil Stabilization - Tree Pruning - Tree Surgery.
Advantages:
Tolerant to damp or green concrete. Water based - Non Toxic - Odour Free - Quick drying. Ease of application- may be applied by brush, roller or spray can be mixed with sand or cement to provide extra strength may be painted with water based acrylic paint. Good chemical resistance- Minimum 20 years life expectancy.
Limitations:
Poor solvent resistance. Do not apply in wet conditions or if rain is imminent.
Preparation:
Surface must be clean and free from contaminations such as oil and grease Clean off any loose particles. Remove any standing water.
Application:
Prime the surface with a 1:1 mixture of ADFLEX-RW and clean water. Apply ADFLEX-RW direct from the can using Brush, Roller or Spray unit. Two coats are recommended, each having an average thickness of 1mm, allow 24 hours between coats.
Below ground tanking:
(Using fabric reinforced Multi-layer system) Apply primer as described above, followed by a base coat of ADFLEX-RW at the rate of 1m2 per litre. Whilst wet, apply a layer of A;C Reo-Fab, reinforcing fabric embedded into the base coat, allow to dry before the application of the top coat. Top coat, apply ADFLEX-RW at the rate of 1m2 per litre.
Packaging:
ADFLEX-RW is supplied in 4ltr, 20ltr and 200ltr.
Clean up:
All tools and equipment should be cleaned up immediately after use with water.
The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.
