Description:
HARD-N-SEAL, is the latest development from the laboratory of ADCRETE Industries, it is a transparent crystal formulated silicate liquid solution, developed for maximum HARDENING-SEALING and DUSTPROOFING of concrete floor etc.
Benifits:
HARD-N-SEAL, when applied to new or old concrete penetrates deep into the concrete surface, depositing a hard compound into the pores, thereby binding the cementious and aggregate components of the concrete.
Recommended uses:
Advantages:
One part no mixing. ease of application. Reduces clean-up time. No discolouration. Dries fast, Odorless. Non-Flammable. Non-corrosive. Compatible with paint and adhesives.
Resistant to:
Mineral and Organic Acids. Oil, Grease and Water.
Surface preparation:
Surface to which HARD-N-SEAL is to be applied must be free of dirt, oil, grease and surface contamination. Surface shall be free of water puddles, and condensation.
Application:
HARD-N-SEAL may be applied by spray, broom or roller. Apply in a uniform and even coating. Shake well before use.
Coverage:
Coverage depends on the porosity of the concrete. As a guide on new concrete an application rate of 4m2 per litre is recommended. Two of three applications are recommended with 24 hours between coats.
Packaging:
HARD-N-SEAL is supplied in 20 litre and 205 litre containers.
Caution:
Clean off with water areas accidentally sprayed, do not allow material to come into contact with glass or aluminum. Avoid contact with skin and eye. If splashed in eyes, flush with water immediately until irritation subsides.
Note:
To remove excess efflorescence which may appear from impurities in the cement, wash with water and scrub with stiff broom. Not recommended on surfaces which are continually damp. Not recommended on coloured surface as it may cause blotchiness.
The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.